Sturdy stand for our HP MFP M477 laser printer in our home office that complements other furniture. The printer is right at the stated weight limit (~50 lbs.) for the stand with full cartridges, but it appears very stable and capable of supporting such a load - time will tell ;-)Other comments regarding assembly are accurate, and I found the instructions useful (only one later step regarding side fillers (step 9?) should be one step earlier to show you insert before putting on front set of legs) if you read through beforehand to get familiar with the process. The reason you only screw the leg/side panel screws in 2/3rds of the way is to hold the bottom shelf up when you tip the frame upside-down to put the frame on the table top, as it sits loosely into the grooves of frame. Those looking for a good looking and sturdy printer stand should not be dissuaded by the assembly process - just take your time and it is worth the 45 minutes or so to put together!