Previous page Next page Previous page Next page Key points to inflate the board - Make sure the air valve pin is at up position before inflate;Make sure the hose is connected to the inflate port of the pump; - Make sure to use the dual action mode for high efficiency; - The pressure gauge is sensitive at 1 PSI, the board will be inflated to the full shape at that time; - When the PSI achieve about 7 PSI, Make sure to change to single action mode for labor saving; Recommended pressure 12-15 PSI. Key points to assemble the paddle - When turning the tension lever, make sure to pull out the inner shaft firstly; Don‘t overturn the tension lever, which will cause the tension level to be break; - Make sure the orientation of the handle and blade, the design is ergonomically, feel the difference with different handling; - The paddle height is recommend to be 4”-6“ higher above your head; - The assembled paddle is floatable for at least one hour, but not the single middle shaft, remember to assemble the paddle before paddling. Key points to attach the leash - When dropping from the board, there will be a force to push the board away from you, also the flow will take away the board from you; - Always remember to attach the leash, which can help save the life when drop off from the board; - The leash we used is 10Ft in length, 7mm cord TPU line and SUS swivel on both ends, mostly the best leash on the market, which is strong, reliable and comfortable. Key points to attach the fins -Ensure the fin box and the fins are clean and free of any debris,the debris will cause the fin slide in the box difficult and may caused damage; -Install the fins after the board was inflated; -Ensure the clip of the fin has been inserted to the right position, which is important to forbid the fin loss during paddling. -Do not over tighten the screw as it can potentially damage the fin and the fin box